Ihr Warenkorb ist leer.

Warenkorb

ALANGATOR LLC.
10/22® TRIMAG MAGAZINE COUPLER

705105457857 100005354

Clamps Together Three Factory Magazines For Fast Reloads

Low-profile, molded polymer coupler clamps together three factory 10/22® magazines to put 30 rounds at your fingertips for super-fast reloads without fumbling for the next mag. More economical and less bulky than high-cap “banana” magazines, and easy to use. Slide the mags onto the TriMag and secure them by tightening the stainless steel crossbolt with a slot-head screwdriver or even a coin. Loosen the bolt to release the magazines for single use again. Get the Ruger® 10/22® Trimag Pouch.

SPECS: Polymer, matte black. Approximately 1¾" (4.5cm) long, 1½" (3.8cm) wide. 1 oz. (69g) wt.

Mehr...

Spannt drei Werksmagazine für schnelles Nachladen zusammen

Der flache, geformte Polymer-Koppler klemmt drei werkseitige 10/22-Magazine zusammen, um 30 Schuss für superschnelles Nachladen zur Hand zu haben, ohne nach dem nächsten Magazin zu suchen. Sparsamer und weniger sperrig als „Bananen“-Magazine mit hoher Kappe und einfach zu bedienen. Schieben Sie die Mags auf den TriMag und sichern Sie sie, indem Sie den Edelstahl-Querbolzen mit einem Schlitzschraubendreher oder sogar einer Münze festziehen. Lösen Sie die Schraube, um die Magazine wieder für den einmaligen Gebrauch freizugeben. Holen Sie sich den Ruger 10/22 Trimag Pouch.

Technische Daten: Polymer, mattschwarz. Ca. 1 "(4,5 cm) lang, 1" (3,8 cm) breit. 1 Unze. (69 g) Gew.

Mehr...

Kundenbewertungen zu ALANGATOR LLC. TRIMAG 10/22® MAG COUPLER

Anzahl der Bewertungen: 14
Von brownells.com: 14
Durchschnittliche Bewertung: 4,8

Great idea (15.06.2010)

Love these things. Unlike other coupler products, this one does not require any glue and holds the mags conveniently. A+

Good mag coupler (09.09.2010)

Holds mags together positively. Goes together and comes apart with a flat-head screwdriver, which is needed to strip the 10/22 anyway. No glue or tape needed.

The only downside is the screw in the middle is aluminum, but then again, you aren't supposed to over-tighten it, so it's a non-issue.

TriMag Coupler in Competition (08.11.2010)

I used the TriMag at the 2010 Ruger Rimfire Championships. I normally shoot competition pistol, but I was talked into buying a 10/22 and shooting this match by a friend. As the match had a 10 round limit for magazines, the TriMag turned out to be the way to go for fast reloads. In addition to the fast reloads, the setup allows the system acts like a tripod. I was able to set the rifle on a barrel in an upright position for a fast start when the buzzer went off, no tripod needed. Cool stuff!

Dang it, now I'm hooked! I plan on getting several more as backups!

Flawless (02.02.2011)

Theres almost nothing to complain about, the only thing is the colour of the screw.

Very good and an excellent idea but... (18.03.2011)

Good stuff just wish they made a 2 magazine version.
the only bad thing I can say about them is that they interfer with the Buttlercreek foldingstock.
so it is not possible to have it folded while the magazine with the coupler are inserted to the gun.

but other then that superb!

Works GREAT. Condense your 10rnd Mags. (07.07.2011)

I purchased 1 of these to try, and once I had it at the range I decided to buy 6 more. I've been filling a box with my 10rnd Ruger Mags over the years and these are a GREAT way to condense those magazines into a usable product again. The 3 mags combined don't hang as low as a single 26rnd Ruger or Butler Creek Mag. I find these a valuable addition to any 10/22, 77/22 or 96/22 Shooter with a pile of old factory mags.

Outstanding Product (16.07.2011)

This has got to be one of the best new products to hit the market in recent years. Outstanding guality, fair price and ease of use. I cannot say enough to praise this item. JUST BUY IT.

30 rounds and no banana mag! (09.08.2011)

I purchased to use with a bi-pod. I Recommend an extended mag release to aid with ease of re-charging rifle.

No High Capacity Troubles! (02.02.2012)

Works great and is especially good for those of you who live in states which restrict high capacity magazines. :)

Snug fit (06.05.2012)

Connects and holds together up to three standard 10-round Ruger hot-lips mags. Gives you 30 rouns capacity but doesn't protrude as far down as a std 30 round mag. Great for benchrest shooting

Good product (24.04.2014)

Just received this today. While I haven't shot my 10/22 utilizing it, there isn't much that can go wrong with it, and I really like the concept. This is a very secure platform for 3 mags and I have no doubts that it will perform as advertised. I don't have anything negative to say about this product, buy it!

Clever idea (22.09.2015)

This is the second TriMag I order. It holds the mags very securely plus makes it easier to manipulate in and out of the magazine well. Well thought out, well made product. It allows for 30 rounds without sticking out like the 25 round banana magazines. Makes a difference when shooting off short bipod.

BTW, it is the second because I bought more mags, first one is still holding out well.

Luisyamaha

Modifications Needed (18.03.2019)

I have one of these things, and it works 100% as designed and intended. However, I just bought one of the new Mag Lula 10/22 mag speed loaders, anticipating a healing thumb. I was sorely disappointing when I discovered that the speed loader will not function when the mags are clamped in the TriMag device. The TriMag protrudes into the space the Lula needs to lock onto the mag. Dang! And a pity. Either the TriMag or the Lula 10/22 speed loader need a redesign pronto. It is surely not practical to have to take the TriMag off the three mags just to reload. The Lula website also states the loader will not work with the mag twinning device either. Info on this site needs to be updated to inform customers of the conflicts. Neither product is "at fault" it's just that one would hope they were compatible.

Easy to use, very good quality (15.01.2020)

After using a friends, I had to have a couple for myself. Smaller than a 25 round magazine and doesn't hang down as much. I take the grandkids out plinking/target shooting and it is easier on me to keep them loaded for them and makes it easier to swap out..

Lesen Sie 14 weitere Bewertungen bei brownells.com

19.9 19.9 1 EUR

Artikel-Nr.: 100005354
ALANGATOR LLC. TRIMAG 10/22® MAG COUPLER 705105457857 Der flache, geformte Polymer-Koppler klemmt drei werkseitige 10/22-Magazine zusammen, um 30 Schuss für superschnelles Nachladen zur Hand zu haben, ohne nach dem nächsten Magazin zu suchen. Sparsamer und weniger sperrig als „Bananen“-Magazine mit hoher Kappe und einfach zu bedienen. Schieben Sie die Mags auf den TriMag und sichern Sie sie, indem Sie den Edelstahl-Querbolzen mit einem Schlitzschraubendreher oder sogar einer Münze festziehen. Lösen Sie die Schraube, um die Magazine wieder für den einmaligen Gebrauch freizugeben. Holen Sie sich den Ruger 10/22 Trimag Pouch.

19.9 EUR 19 19,90 € *

Lieferzeit ca. 21-30 Tage.
mehr als 10 Stk. im USA Lager.

Eigenschaften: Farbe: Black Hersteller/Modell: Ruger Modell: 10/22

Auf die Wunschliste setzen

Details

Auf die Wunschliste setzen

Eigenschaften

Farbe: Black Hersteller/Modell: Ruger Modell: 10/22 Versandgewicht: 0,023kg Höhe: 38mm Breite: 46mm Länge: 66mm

Artikeldetails

US-Exportklassifizierung: 0A501.x

Clamps Together Three Factory Magazines For Fast Reloads

SPECS: Polymer, matte black. Approximately 1¾" (4.5cm) long, 1½" (3.8cm) wide. 1 oz. (69g) wt.

Mehr...

Spannt drei Werksmagazine für schnelles Nachladen zusammen

Technische Daten: Polymer, mattschwarz. Ca. 1 "(4,5 cm) lang, 1" (3,8 cm) breit. 1 Unze. (69 g) Gew.

Mehr...

Kundenbewertungen zu ALANGATOR LLC. TRIMAG 10/22® MAG COUPLER

Anzahl der Bewertungen: 14
Von brownells.com: 14
Durchschnittliche Bewertung: 4,8

Great idea (15.06.2010)

Love these things. Unlike other coupler products, this one does not require any glue and holds the mags conveniently. A+

Good mag coupler (09.09.2010)

TriMag Coupler in Competition (08.11.2010)

Flawless (02.02.2011)

Theres almost nothing to complain about, the only thing is the colour of the screw.

Very good and an excellent idea but... (18.03.2011)

Works GREAT. Condense your 10rnd Mags. (07.07.2011)

Outstanding Product (16.07.2011)

This has got to be one of the best new products to hit the market in recent years. Outstanding guality, fair price and ease of use. I cannot say enough to praise this item. JUST BUY IT.

30 rounds and no banana mag! (09.08.2011)

I purchased to use with a bi-pod. I Recommend an extended mag release to aid with ease of re-charging rifle.

No High Capacity Troubles! (02.02.2012)

Works great and is especially good for those of you who live in states which restrict high capacity magazines. :)

Snug fit (06.05.2012)

Connects and holds together up to three standard 10-round Ruger hot-lips mags. Gives you 30 rouns capacity but doesn't protrude as far down as a std 30 round mag. Great for benchrest shooting

Good product (24.04.2014)

Clever idea (22.09.2015)

Modifications Needed (18.03.2019)

Easy to use, very good quality (15.01.2020)

Lesen Sie 14 weitere Bewertungen bei brownells.com

Kunden kauften auch

VOLQUARTSEN RECOIL BUFFER PIN
10/22® RECOIL BUFFER PIN

VOLQUARTSEN

Lieferzeit ca. 21-30 Tage.
3 Stk. im USA Lager. Lieferzeit ca. 21-30 Tage.
3 Stk. im USA Lager.

21,90 € *

Stifte für Verschlusshülsen

0 (0)

VOLQUARTSEN BLUE 10/22® BOLT RELEASE
RUGER® 10/22® BOLT RELEASE

VOLQUARTSEN

Nicht auf Lager, Nachbestellung ist momentan nicht verfügbar. Nicht auf Lager, Nachbestellung ist momentan nicht verfügbar.

21,90 € *

0 (0)

VOLQUARTSEN EXTENDED BOLT HANDLE
RUGER® 10/22® EXTENDED BOLT HANDLE

VOLQUARTSEN

Nicht auf Lager, Nachbestellung ist momentan nicht verfügbar. Nicht auf Lager, Nachbestellung ist momentan nicht verfügbar.

74,90 € *

Ladehebel

0 (0)

WOLFF KIT 18075 TUNE-UP PAK
RUGER® 10/22® RIFLE TUNE-UP KITS

WOLFF

Lieferzeit ca. 21-30 Tage.
mehr als 10 Stk. im USA Lager. Lieferzeit ca. 21-30 Tage.
mehr als 10 Stk. im USA Lager.

14,90 € *

Federn

0 (0)

KNS PRECISION, INC. ADJUSTABLE GAS PISTON SYSTEM AKM
AK ADJUSTIBLE GAS PISTON

KNS PRECISION, INC.

Auf Lager Lieferzeit ca. 21-30 Tage.
4 Stk. im USA Lager.

214,90 € * 214,90 € - 249,90 €*

Gaskolben

0 (0)

Anmeldung

Kennwort vergessen?
Registrieren

Site Map

PRODUKT GRUPPEN

Ordering

Kundenservice

Willkommen bei Brownells, dem führenden Händler für Waffenteile, Werkzeug und Zubehör für Waffen in der Benelux!

Unser Versprechen

Wenn Sie gerne schießen oder mit Waffen arbeiten, ob für Hobby, Beruf oder Sport, sind Sie bei uns richtig! Keine Extrakosten für Zoll und kein Mindestbestellwert!

Seit über 75 Jahren vertrauen Schützen, professionelle Büchsenmacher, Enthusiasten, Militär / Polizei und Waffen-Tüftler den qualitativ hochwertigen Waffenteilen und -zubehör von Brownells.

Sie finden bei uns mehr als 50.000 Produkte, darunter einzigartige Waffenteile, Zubehör, Büchsenmacher-Werkzeuge, Munition und andere Produkte zur Wartung, Instandsetzung und Tuning Ihrer Waffen.